Mtq 310 Assembly Paint #2
Settings
-
+
Paint quiz for assembly
- 1.Employee must wear chemical resistant gloves while changing paint drums
- A.
True
- B.
False
- 2.Painted masking tape should be disposed of
- A.
In the nearest garbage can
- B.
By rolling it up and tossing it under a shelf
- C.
In the solid paint waste drum
- D.
Answer option 4
- 3.Viscosity test must always be completed upon startup of a new tote or drum and upon a long shut down period of greater than__________ hours
- 4.The target dry mil thickness should be between ____ and _____
- A.
1 and 2
- B.
3 and 4
- C.
0 and 2
- D.
1 and 4
- 5.Dry mil thickness should be checked:
- A.
On whatever part of the product the paint happens to be in the target thickness range
- B.
Only when you feel there may be a problem with the paint
- C.
On all surfaces, with special attention to the axle seat areas and hard to reach corners
- D.
On every part you paint
- 6.When applicable, ______ out of every 16 beams should be checked for proper undercoating coverage. Verify 100% coverage inside of beam using a _____________
- 7.In order to measure paint drum viscosity, you need:
- A.
A digital thermometer
- B.
A Zahn viscosity cup
- C.
A stopwatch
- D.
All of the above
- 8.Should any of the aforementioned Inspectin and Quality requirements not be met, you should:
- A.
Contact your supervisor
- B.
Ignore the problem
- C.
Keep going and document it in KBM
- D.
Send all product from the last check back through the paint booth
- 9.Paint booth air-flow data collection must be performed no less than _____ times a day or any time the booth air-flow is in question.
- 10.The surface coating shall be free from runs and sags
- A.
True
- B.
False
- 11.What is MMFF663?
- A.
Daily TPM Production Log
- B.
Bystronic laser index
- C.
Manufacturing form for second person paint verification
- D.
None of the above
- 12.
- A.
Hangers
- B.
Uppers
- C.
Axle Seat area of Beams
- D.
Shock Clevis
Back to top